* Use Zephyr auto CCC discovery instead of doing it ourselves.
* Split service versus characteristic discovery into dedicated
steps in the flow.
* Fix for not searching properly when connecting to a peripheral
a second time.
* GATT characteristic allowing passng data + behavior
label to invoke the behavior on the peripheral side.
* Behaviors have a locality setting to specify where they run.
* Build reset/power/RGB on peripheral.
This is a generalization of the existing concept of tri-layer support
that's already well known. Essentially, a conditional-layer
configuration activates a particular layer (the then-layer) when one or
more other layers (the if-layers) are activated.
This is commonly used on ortho keyboards to activate a third "adjust"
layer while the primary two layers ("lower" and "raise") are active.
* Add optional `hold-trigger-key-positions` hold-tap configuration
* Leverage configuration for decision making around when to trigger
hold decision in hold-taps.
* Add docs for new configuration.
* Tests for the new config/decision logic.
Recent refactoring of the font handling seems to have broken the display
of the last symbol of the output status widget. From my analysis the
last symbol is truncated because the buffer simply is too small.
Increasing the buffer size to 9 fits all three possible symbols.
* Add ZMK_HID_CONSUMER_REPORT_USAGES choice to allow choosing
between full consumer usage range, with poor OS compat,
or basic consumer usage range, with broader compat.
* Add new Kconfig settingsx to allow selecting system or dedicated
work queue for performing UI updates.
* Allow UI updates to not block other system tasks when display is
updating, especially important for e-ink displays.
* Workaround for ensuring macOS pairing happens early enough,
for their stack, we require encryption for the hids report map and
report ref characteristics as well, to trigger pairing ealier in the
connection process for macOS.
A hold-tap timer event would be triggered too soon if the hold-tap
was delayed for longer than its tapping-term. This may cause
accidental hold behavior when the correct behavior would be tap.
By queuing the timer event instead of executing it immediately,
other delayed events get a chance to be processed properly.
The current combo completion check only makes sure the last key in the
combo is set. This works when the combo is typed correctly initially, or
when reraising events in a combo of length two. However, it fails for
longer combos since the last event in pressed_keys might be set, but the
first (or subsequent) event in pressed_keys can be NULL thanks to
release_pressed_keys.
Also added a regression test.
Quick release for sticky keys failed for non-layer keys. The sticky key
was released just before the key that was supposed to be modified was
handled.
The issue was caused by an error in the sticky key logic, which released
the sticky key before handling the key up event.
Fixes#696.
To properly retrigger hold-taps when a combo is not activated, some
position down events are reraised instead of released. The corresponding
position up events were never reraised, causing a potential stuck key.
This is an improvement on retro-tap, solving the 'flashing hold' issue
users people experience.
When the tapping-term expires, the hold key is normally pressed. When
retro-tap is enabled, this is undesirable; only an interrupted hold-tap
should trigger the hold behavior.
This change disables the hold behavior for the 'STATUS_HOLD_TIMER'
state when retro-tap is enabled, and makes sure the
'STATUS_HOLD_INTERRUPT' state will be triggered when appropriate.
Peter Johanson