By setting CONFIG_DEBUG, the native_posix builds will not be optimized
which makes debugging them much nicer.
By setting CONFIG_SYS_CLOCK_TICKS_PER_SEC to 1000, debug prints have a
higher resolution and not always show up as multiples of 10ms.
Quick release for sticky keys failed for non-layer keys. The sticky key
was released just before the key that was supposed to be modified was
handled.
The issue was caused by an error in the sticky key logic, which released
the sticky key before handling the key up event.
Fixes#696.
To properly retrigger hold-taps when a combo is not activated, some
position down events are reraised instead of released. The corresponding
position up events were never reraised, causing a potential stuck key.
This is an improvement on retro-tap, solving the 'flashing hold' issue
users people experience.
When the tapping-term expires, the hold key is normally pressed. When
retro-tap is enabled, this is undesirable; only an interrupted hold-tap
should trigger the hold behavior.
This change disables the hold behavior for the 'STATUS_HOLD_TIMER'
state when retro-tap is enabled, and makes sure the
'STATUS_HOLD_INTERRUPT' state will be triggered when appropriate.
* Public type for HSB led color.
* New API for calculating "next" HSB based on current
state.
* Update behavior to convert the increment/decrement
commands to absolute command as well.
* feat(nibble): add underglow support for nice_nano builds
* feat(nibble): add encoder to top, left most column to match standard assembly documentation
* refactor(nibble): add layer labels
* feat(nibble): add support for optional display ; off by default
* feat(nibble): add README
* fix(nibble): adjust oled rotation for easier reading
* fix(nibble): add additional note about enabling oled
* refactor(nibble): convert keymap to use tabs instead of spaces
* refactor(nibble): enable oled in dts/overlay by default
* refactor(nibble): cleanup alignment and formatting in nibble keymap
* refactor(nibble): re-align top most row of keymap to be sensible
* refactor(nibble): cleanup kscan map alignment
* refactor(nibble): indent first row of map/transform to properly align with physical columns
* fix(nibble): remove dangling code block from readme
Co-authored-by: KemoNine <mcrosson@kemonine.info>
Add a little delay so any capacitors connected to the ADC for the BVD can charge up when using power_gpios
Co-authored-by: Jasper Smit <jrhrsmit@gmail.com>
* Use lesser-known DT features to skip behaviors not referenced
in the user keymap
* Update the behaviors to skip code if no nodes found.
* Remove some empty config/data structs where unused in
behaviors.
Tap-and-hold a hold-tap to hold the tap behavior so it can repeat.
After a tap, if the same key is pressed within `quick_tap_ms`, the
tap behavior is always picked.
This is useful for things like `&ht LSHFT BACKSPACE` where holding
the backspace is required.
Implements #288.
* Add easier macros for conditional polling/interrupt code.
* Properly continue polling on intervals, without extra
enable/disable code for pins that is superfluous when not trying to
deal with interupts firing.
* Fix to allow multiple GPIO drivers when doing splits w/ IO expanders
this makes LS(LEFT_CONTROL) work as if shift and control were both
pressed explicitly. Previously, the left shift would have been released
as soon as another key was pressed. The implicit behavior is useful in
case of LS(NUMBER_1) when rolling over to other keys.
Also see #361.
Okke Formsma